In the process of running the second hand Guangzhou engraving machine, there will be various problems with the second hand Guangzhou engraving machine. At this time, we must find out the cause and find out what is the specific problem that causes the second hand Guangzhou engraving machine to fail to work normally. Only by finding out the cause, can the manufacturer of the engraving machine find the correct solution.
Common problems of the engraving machine:
1. The main shaft motor is short circuited, the bearing is damaged, the used precision carving machine is used, the rotor is broken, and the rotor thread is slippery, etc.
2. The lead screw nut of X axis and Y axis fell off, and the machine became loose.
3. The Z-axis 608 bearing is often damaged, resulting in the Z-axis knife cutting.
4. The computer signal of the engraving machine cannot be transmitted.
5. The Z-axis lead screw is noisy when it moves up and down for a long time.
6. The water pump makes a simple noise or does not discharge water.
7. The dust prevention function of Z-axis and Y-axis is poor, and there is too much dust.
8. Limit switches and limit switch lines are easy to be damaged when used.
9. The frequency converter is short circuited, the stepping motor does not rotate, and there is a gap between the upper and lower parts of the used wide carving machine with broken shaft.
Analysis of the causes of the defects of the engraving machine:
1. The software transmission rate is inconsistent with the baud rate setting of the engraving machine.
2. Second hand problem of computer serial port wide carving machine.
3. Software parameter settings are incorrect Second hand accurate second hand wide carving machine.
4. The machine is not connected to the computer.
Solution to problems of the engraving machine:
1. Set parameters from scratch
2. Press the secondary "Offline" key of the Guangzhou Sculpture Sculpture Machine to turn off the offline light.
3. Use another serial port.
4. Second hand set the baud rate from scratch.
We have strict quality control processes, testing equipment and means, and full-time quality control departments and posts.
